Table of Contents
Related FAQs
FAQ Categories
My instrument shuts down after taking a measurement
In older versions of firmware, the instrument shut down after experiencing a fatal error. In this case, the instrumentโs memory is usually full. Make sure you have backed up any important measurements to a computer with the USB connection. Switch the instrument on, and in the menu, select โDelete All Batchesโ.
If this does not resolve the issue, the instrument will require repair with an accredited service centre.
You can contact an accredited service centre for details about whether there is a firmware upgrade available for your instrument.
Related products
Aesthetixยฎ: The Ultimate Surface Finish Solutionโ
- Fully characterise all aspects of appearance perception - Why does this matter?
- Modular solution: Surface Brilliance | Textureย | Effect Finish
- Aesthetixยฎ can be used in-laboratory, portable in-field, inline in the production environment or as part of a Cobot / Robot solution
- Measures flat surfaces, curved parts and small surface areas
- Affordable technology starts at $7,500
AFNOR Viscosity Flow Cup
- 2mm - 8mm orifice diameter
- 15 โ 3000 cSt viscosity range
- 25 -150 sec flow times
- Supplied with a certificate of conformity
- Sheen 419/2.5, 419/4, 419/6 & 419/8 equivalent
ASTM D1200 Viscosity Flow Cup
- 2.1mm - 5.8mm orifice diameter
- 10 โ 1200 cSt viscosity range
- 30-100 sec flow times
- Supplied with a certificate of conformity
- Sheen 406/1, 406/2, 406/3, 406/4 & 406/5 equivalent
Bespoke cutter die – 1 or 2 of the same shape
Bespoke cutter die - 1 or 2 of the same shape
